Insert your first block

A tool on the toolbar works like a tool in a graphics editor. You arm it first. Your next click in the canvas inserts its block.

Arm a tool and click the canvas

  1. Open a post in the editor.
  2. Click Heading on the toolbar. The button is highlighted. The tool is now armed.
  3. Click in the canvas where you want the heading.

The heading goes in at the point you clicked. The toolbar returns to Select.

Where the block goes

  • Click on the top half of a block to insert before it. Click on the bottom half to insert after it.
  • Click on a block inside a Group, and the new block goes in that Group.
  • Click in the space between two blocks to insert between them.
  • Click on the post title to insert at the top of the post.
  • Click on an empty Group to insert inside it.
  • Click below the last block to add the block to the end of the post.

If the block cannot go at that point, a notice says that it cannot be inserted here. The tool stays armed, so you can click a different point.

Insert the same block again

  • Hold Shift when you click in the canvas. The block goes in, and the tool stays armed.
  • Press Escape to return to Select.
  • Click the armed tool again to disarm it.

Drag a tool into the canvas

Drag a tool from the toolbar and drop it in the canvas. The block goes in where you drop it.

The editor’s “+” buttons

While a tool is armed, EditRail hides the editor’s own “+” buttons between blocks and beside an empty block. This sends your click to the armed tool.

To keep the “+” buttons, open Toolbar settings. Under Inserting, clear the checkbox. With the checkbox clear, a “+” button can take a click that you meant for the armed tool.

Use the keyboard

Press Enter on a tool to arm it. Then press Ctrl+Enter (Cmd+Enter on a Mac). The block goes in after the selected block. See Keyboard use and screen readers.